SANRAD I3.1.1205 - Manual (Page 166)

8-14 SANRAD V-Switch CLI User Manual
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-vol VOLUME SNAPSHOT SOURCE
VOLUME MANDATORY Mirror7
Reactivating a Snapshot Volume
volume snapshot activate
You need one parameter to (re)activate a snapshot volume:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-vol VOLUME SNAPSHOT SOURCE
VOLUME MANDATORY Mirror7
Viewing Snapshot Volumes
You can view all created snapshot volumes using the CLI command volume
snapshot show
. Use this command to view the source and snapshot
volumes, the time the snapshot was created and the percent capacity utilization.
At user-defined load threshold utilization, an alert to resize the snapshot is sent.
volume snapshot show
Table 8-1: All Snapshot Volumes
Source Snapshot Date & Time Utilization
Mirror3 Snp1Mir3 12/12/02
13:00:00 80%
Mirror3 Snp2Mir3 12/12/02
14:00:00 60%
You can view all snapshots of a single source volume using the CLI command
volume snapshot list
.
volume snapshot list
You need one parameter to view a volume’s snapshots:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-vol VOLUME SNAPSHOT SOURCE
VOLUME MANDATORY Mirror7