SANRAD I3.1.1205 - Manual (Page 198)

10-12 SANRAD V-Switch CLI User Manual
-ip IP ADDRESS IP ADDRESS
ASSIGNING TO THE
INTERFACE PORT
MANDATORY 212.199.43.57
with a different IP
address will not reset
the network port
address. It will add
another IP address to
the network port
-im IP MASK IP NET MASK OPTIONAL
DEFAULT :
255.255.255.0
-act ACTIVITY IF IP ADDRESS IS
ACTIVE TO EXPOSE
VOLUMES
. U SE
INACTIVE STATUS
TO ALLOW
FAILOVER
.
OPTIONAL
DEFAULT : 1
( ACTIVE ).
2( INACTIVE )
1
Example:
IP address 212.199.43.57 is added to interface eth1 for a total of two IP addresses
assigned to interface eth1.
ip config set –if eth1 –ip 212.199.43.57
10225
212.199.12.67
212.199.12.70
212.199.75.66 212.199.43.46
212.199.43.56
212.199.43.57
Figure 10-1. Adding an Interface IP Address
Removing an Interface IP Address
If you are working in
a V-Switch cluster,
the interface IP must
be removed on both
V-Switches.
You can remove an IP address from the network ports.
ip config remove
You need to define one parameter to remove a network port IP address:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-ip IP ADDRESS IP ADDRESS TO
REMOVE FROM THE
NETWORK
INTERFACE PORT
MANDATORY 212.199.12.70