SANRAD I3.1.1205 - Manual (Page 53)

Chapter 4: V-Switch Configuration 4-1
4
V-Switch Configuration
IN THIS
CHAPTER After the V-Switch is connected properly to the physical disks,
management station and the network and powered up, the V-
Switch must be configured.
The basic V-Switch configurations define the management IP
configurations and can be done either via the LCD panel for the V-
Switch 3000 or the RS232 console port for both the V-Switch 3000
and the V-Switch 2000.
Once the management port is configured, any other V-Switch
configuration can be executed through the management port or
continued through the RS232 console port.
Disks and LUNs connected to the storage ports are discovered and
registered automatically.
Introduction to
Managing the V-
Switch
Initial V-Switch
Configuration
Changing
Management
Parameters
Configuring the
Storage Ports
Configuring the
Network Ports
Discovering iSCSI
Targets
Configuring iSCSI
Portals
Configuring IP
Routing