SANRAD I3.1.1205 - Manual (Page 58)

4-6 SANRAD V-Switch CLI User Manual
You must define
only one port for
management. Both
can not be active at
the same time.
The physical Mgnt
port can not be used
for iSCSI traffic (out-
of-band)
The ETH1 port can
be used for
management and
iSCSI traffic
simultaneously (in-
band.)
LCD Buttons
The V-Switch 3000 has buttons next to its LCD display. You can use these to
assign the initial setup parameters.
To assign management IP for V-Switch 3000 via the LCD buttons:
ƒ Toggle the LCD buttons to set an IP address and IP mask.
For example: IP Address: 192.168.1.1
IP Mask: 255.255.255.0
ƒ Select which physical port you want to use for management:
Mgnt or Eth1 (first iSCSI port).
Changing Management Parameters
After logging in to the V-Switch, you can change the general management
parameters and Telnet communications port as well as add user login profiles
and hardware temperature scale.
Changing General Management Parameters
You can change V-Switch management parameters (IP address and mask) or
UDP port number as well as include details of whom to contact in the event of
technical difficulties and which read/write communities to send traps to. Use
the CLI command device set to add or change management parameters.
This command will not appear in the CLI menu until the V-Switch is initialized.
device set
You can define or change thirteen parameters using this command:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-n NAME USER - ASSIGNED
NAME FOR THE V-
S WITCH
OPTIONAL VSwitch1
-ip MANAGEMENT IP
ADDRESS
IP ADDRESS OF THE
MANAGEMENT PORT
OPTIONAL 212.199.43.47