SANRAD I3.1.1205 - Manual (Page 250)

11-36 SANRAD V-Switch CLI User Manual
volume mirror sync show
This command shows the status of all mirrored volumes where the “mirror
sync” operation was activated since last V-Switch reset.
volume mirror show
Volume Alias Source Alias Operational
Status Progress
Mirror8 Mirror2 Synchronizing 60%
Mirror4 Mirror3 Last sync
succeeded
100%
Mirror 12 Mirror10 none -
volume mirror sync start
This command starts synchronization of mirrored volumes. Use this command
in the following three cases:
1. After adding a mirror copy to an existing volume.
2. To restore a mirrored volume on a disk after a disk failure.
3. When one of the mirror legs is in the “Need Sync” state.
volume mirror sync start
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-src SOURCE ALIAS OF SOURCE
VOLUME TO COPY MANDATORY Mirror2
-dst DESTINATION ALIAS OF VOLUME
TO COPY TO MANDATORY Mirror8