SANRAD I3.1.1205 - Manual (Page 326)

A-26 SANRAD V-Switch User Manual
STEP 2. P OWER UP STORAGE DEVICE
Power up the JBOD appliance first to allow both V-Switches to register it in
their network scan.
STEP 3. POWER UP V-S WITCHES
Connect the power cord to V-Switch 1 and then to the electric socket. The
V-Switch powers up. The fan assembly is running and the LCD panel
displays:
V-Switch 3000
Status: OK
Connect the power cord to V-Switch 2 and then to the electric socket. The
V-Switch powers up. The fan assembly is running and the LCD panel
displays:
V-Switch 3000
Status: OK
STEP 4. I NITIALIZE V-S WITCH 1
Use the LCD display and control buttons on V-Switch 1 to configure the V-
Switch management port IP address and mask.
ƒ Toggle to the IP Configure ETH1 Port screen.
ƒ Press Enter. The IP Configuration screen appears.
IP CONFIG
ƒ Press Enter again. The IP Config ETH1 Port screen appears.
IP Config
ETH1 Port
ƒ Press Enter. The Insert IP screen appears.
Insert IP
0 0 0.0 0 0.0 0 0.0 0 0
ƒ Enter the management port IP address. The left/right buttons toggle
between places in the IP address. The up/down buttons scroll between
numbers. Press Enter after inputting the full address.
Insert IP
2 1 2.1 9 9.0 4 3.0 4 1
ƒ Press Enter to enter the IP address and progress to the IP Mask screen.
Mask
2 5 5.2 5 5.2 5 5.0 0 0
ƒ If you want to change from the default mask, use the left/right buttons to
toggle between places in the mask and the up/down buttons scroll between
numbers.