SANRAD I3.1.1205 - Manual (Page 205)

Chapter 10: Routine V-Switch Maintenance 10-19
Modifying a Cluster
Both V-Switches in
the cluster must be
modified.
You can modify a cluster’s parameters.
cluster set
You need to define three parameters to modify a cluster’s parameters:
S WITCH P ARAMETER D EFINITION S TATUS E XAMPLE
-kai KEEP ALIVE
INTERVAL TIME BETWEEN
ALIVE SIGNALS
FROM NEIGHBORS MANDATORY IF
CHANGING 5
-sint SUSPICIOUS
INTERVAL TIME FROM WHEN A
SIGNAL WAS
EXPECTED BUT NOT
RECEIVED MANDATORY IF
CHANGING 10
-fint FAILOVER INTERVAL TIME WHEN
SUSPICIOUS
INTERVAL IS
EXCEEDED MANDATORY IF
CHANGING 10
Enabling and Disabling Failover
If you want to break a cluster or need to take a V-Switch off-line, you must first
disable V-Switch failover. Use the CLI command cluster failover
disable
to disable this functionality. This command must be executed on
both V-Switches in the cluster.
cluster failover disable
If you want to restore a cluster or after you bring the V-Switch back on-line, you
need to re-enable the failover functionality. Use the CLI command cluster
failover enable
to re-enable this functionality. This command must be
executed on both V-Switches in the cluster.
cluster failover enable