SANRAD I3.1.1205 - Manual (Page 44)

3-4 SANRAD V-Switch CLI User Manual
1
026
9
act
1 GB 100
Power
Sys OK
Scale
FC/SCSI
1
2
3
5
6
7 7 7 8
act act act
1 GB 1 GB
4 6 6
Figure 3-3. V-Switch 3000 LEDs
Surface Mounting
The V-Switch 3000 chassis is manufactured with four chassis feet. The V-Switch
3000 is ready to be mounted on any secure flat surface. If you plan to rack
mount the V-Switch 3000, continue with “Rack Mounting.”
Rack Mounting
The V-Switch 3000 chassis can be mounted on a 19-inch rack.
The V-Switch 3000 is shipped with an accessory packet of hardware. This
packet includes two L-brackets, two rear mounts (one left and one right)
and ten bracket screws for mounting the L-brackets.
You need the following tools to rack-mount the V-Switch 3000:
ƒ A Philips screwdriver suitable for L-bracket screws
ƒ Eight rack-post screws (and clips if necessary) suitable for the
equipment rack; four for the front mounts and four for the rear mounts
ƒ A screwdriver suitable for the rack-post screws
Remove the rubber feet from the bottom of the V-Switch before beginning the
rack mount to ensure a proper fit in the rack enclosure.