SANRAD I3.1.1205 - Manual (Page 57)

Chapter 4: V-Switch Configuration 4-5
RS232 Serial Connection
To initialize the V-Switch via an RS-232 serial connection:
ƒ Connect the cable to the appropriate port on the management server,
and open a Terminal session. Set the following parameters in the
terminal:
P ARAMETER S YSTEM R EQUIREMENT
C ONFIG S ERIAL P ORT C OM X ( ACCORDING TO YOUR PHYSICAL PORT CONNECTION )
B ITS PER SECOND 115200
D ATA B ITS 8
P ARITY NONE
S TOP B ITS 1
F LOW C ONTROL NONE
E MULATION A UTODETECT
Figure 4-2. Terminal Properties