TANDBERG D14049.01 - Manual (Page 102)

0 D 14049.01
07.2007 0
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance Appendices
Firewall
Traversal
Configuring the VCS as a Traversal Client
Configuring a Traversal Client Zone
VCS Configuration > Zones .
You will be taken to the Zones page.
Click on the name of the zone you wish to
configure.
You will be taken to the
Edit Zone page.
xConfiguration Zones Zone
•
•
Retry interval
Specifies the interval in seconds with which a
failed attempt to establish a connection to the
traversal server should be retried.
H.323 mode
Determines whether H.323 calls will be
allowed to and from this zone.
H.323 port
Specifies the port on the traversal server to
be used for H.323 firewall traversal calls.
H.323 protocol
Determines which of the two firewall traversal
protocols to use for calls to the traversal
server.
SIP mode
Determines whether SIP calls will be allowed
to and from this zone.
SIP port
Specifies the port on the traversal server to
be used for SIP calls from this VCS
SIP transport
Determines which transport type will be used
for SIP calls to and from the traversal server.
Primary address
Specifies the IP address or FQDN of the
traversal server.
Alternate 1 - Alternate 5 Address
Specifies the IP addresses or FQDNs of any
alternates configured on the traversal server.
Remember to Save your changes.
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Firewall Traversal