TANDBERG D14049.01 - Manual (Page 141)

D 14049.01
07.2007 4
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xConfiguration
Zones
cont... LocalZone
cont... DefaultSubZone
cont... Bandwidth
cont... Total Mode: <None/Limited/Unlimited>
Determines whether the Default Subzone has a limit on the total bandwidth being
used by its endpoints at any one time.
None : no bandwidth will be available.
Limited : there will be a limit on the bandwidth.
Unlimited : there will be no limit on the bandwidth.
Limit: <..00000000>
(applies only if Mode is set to Limited)
Sets the total bandwidth limit (in kbps) of the Default Subzone.
SubZone [..00] Bandwidth PerCall Inter Mode: <None/Limited/Unlimited>
Determines whether there is a limit on the band-
width for any one call to or from an endpoint in this
subzone.
None : no bandwidth will be available.
Limited : there will be a limit on the bandwidth.
Unlimited : there will be no limit on the bandwidth.
Limit: <..00000000>
(applies only if Mode is set to Limited)
Specifies the bandwidth limit (in kbps) on any one call
to or from an endpoint in this subzone
Intra Mode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth
for any one call between two endpoints within this
subzone.
None : no bandwidth will be available.
Limited : there will be a limit on the bandwidth.
Unlimited : there will be no limit on the bandwidth.
Limit: <..00000000>
(applies only if Mode is set to Limited)
Specifies the bandwidth limit (in kbps) for any one
call between two endpoints within this subzone.