TANDBERG D14049.01 - Manual (Page 132)

D 14049.01
07.2007 3
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xConfiguration
Call Services CallsToUnknownIPAddresses: <Off/Direct/Indirect>
Determines the way in which the VCS will attempt to call systems which are not registered with it or one of its neighbors.
Direct : Allows an endpoint to make a call to an unknown IP address without the VCS querying any neighbors. The call setup would occur just as it would if the
far end were registered directly to the local system.
Indirect : Upon receiving a call to an unknown IP address, the VCS will query its neighbors for the remote address, relying on the response from the neighbor to
allow the ability for the call to be completed; connecting through the routing rules as it would through the neighbor relationship.
Off : This will not allow any endpoint registered directly to the VCS to call an IP address of any system not also registered directly to that VCS.
Fallback Alias: <S: 0, 60>
Specifies the alias to which incoming calls are placed for calls where the IP address or domain name of the VCS has been given but no callee alias has been
specified.
Ethernet Speed: <Auto/0half/0full/00half/00full/000full/None>
Sets the speed of the Ethernet link.
Auto : the VCS will automatically determine the speed to be used.
10half : a speed of 10half will be used.
10full : a speed of 10full will be used.
100half : a speed of 100half will be used.
100full : a speed of 100full will be used.
1000full : a speed of 1000full will be used.
None: the VCS will automatically determine the speed to be used.
Note: You must restart the system for any changes to take effect.
ExternalManager Address: <S: 0, 8>
Sets the IP address or FQDN of the External Manager.
Path: <S: 0, 55>
Sets the URL of the External Manager.
H33 Gatekeeper AutoDiscovery Mode: <On/Off>
Determines whether or not the VCS responds to gatekeeper discovery requests from endpoints.
On : the VCS will respond to requests.
Off : the VCS will not respond to requests.
CallSignaling PortRange Start: <04..65534>
Specifies the lower port in the range to be used by calls once they are established.
End: <04..65534>
Specifies the upper port in the rage to be used by calls once they are established.