In order for locally registered endpoints to use
ENUM dialing, you must configure an ENUM
zone for each ENUM service used by remote
endpoints. To do this:

VCS Configuration > Zones

You will be taken to the

Zones

page.

Click

New

You will be taken to the

Create Zone

page.

Enter the zone

Name

and select a

Type

ENUM

Click

Create Zone

You will be taken to the

Edit Zone

page.

xCommand ZoneAdd
xConfiguration Zones Zone

[1..200]

•

•
•

ENUM Dialing for Outgoing Calls

Any number of ENUM zones may be
configured on the VCS.
You should configure at least one

ENUM zone for each DNS suffix that your
endpoints may use.

Normal zone pattern matching and
prioritization rules will apply to ENUM
zones.

Name

Assigns a name to this zone.

Type

For ENUM zones, this will be

ENUM

Hop count

Specifies the hop count to be used when
sending an alias search request to this zone.
If the search request was received from
another zone and already has a hop count
assigned, the lower of the two values will be
used.

DNS suffix

The DNS zone that is to be queried for a
NAPTR record. This suffix is appended to the
transformed E.164 number in an attempt to
find a matching NAPTR record.

H.323 mode

Determines whether or not H.323 records will
be looked up for this zone.

SIP mode

Determines whether or not SIP records will be
looked up for this zone.

Match1 - Match5

These sections allow you to specify any
filtering criteria and/or transforms you wish to
apply to this zone. See

Configuring Matches

for ENUM zones

and

Configuring Transforms

for ENUM zones

for full information on how the