TANDBERG D14049.01 - Manual (Page 154)

D 14049.01
07.2007 54
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xCommand
xCommand Description Parameters
SubZoneAdd Adds and configures a new subzone. SubZoneName (r) : <S: , 50>
Assigns a name to this subzone.
Address: <S: 0, 39>
Specifies an IP address used (in conjunction with the IP Prefix Length) to identify a subnet to be assigned to this subzone.
PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP address which must match for an IP address to belong in this subzone.
TotalMode: <None/Limited/Unlimited>
Determines whether this subzone has a limit on the total bandwidth of calls being used by its endpoints at any one time.
Total: <..00000000>
Sets the total bandwidth limit (in kbps) of this subzone (applies only if Mode is set to Limited).
PerCallInterMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call to or from an endpoint in this subzone.
PerCallInter: <..00000000>
Specifies the bandwidth limit (in kbps) on any one call to or from an endpoint in this subzone (applies only if Mode is set
to Limited).
PerCallIntraMode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth for any one call between two endpoints within this subzone.
PerCallIntra: <..00000000>
Specifies the bandwidth limit (in kbps) on any one call between two endpoints within this subzone.
SubZoneDelete Deletes a subzone. SubZoneId (r) : <..00>
The index of the subzone to be deleted.