TANDBERG D14049.01 - Manual (Page 144)

D 14049.01
07.2007 44
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xConfiguration
Zones
cont... LocalZone
cont... TraversalSubZone Bandwidth PerCall Mode: <None/Limited/Unlimited>
Determines whether there is a limit on the bandwidth of any one traversal call be-
ing handled by the VCS.
None : no bandwidth will be available.
Limited : there will be a limit on the bandwidth.
Unlimited : there will be no limit on the bandwidth.
Limit: <..00000000>
(applies only if Mode is set to Limited)
Specifies the bandwidth limit (in kbps) applied to any one traversal call being
handled by the VCS.
Total Mode: <None/Limited/Unlimited>
Determines whether or not there is a limit to the total bandwidth of all traversal
calls being handled by the VCS.
None : no bandwidth will be available.
Limited : there will be a limit on the bandwidth.
Unlimited : there will be no limit on the bandwidth.
Limit: <..00000000>
(applies only if Mode is set to Limited)
Specifies the total bandwidth (in kbps) allowed for all traversal calls being handled
by the VCS.
Zone [..00] ENUM DNSSuffix: <S: 0, 128>
Specifies the domain to be appended to the transformed E.164 number to create an ENUM host name which this zone is then queried
for.
H33 Mode: <On/Off>
Determines whether H.323 calls will be allowed to and from this zone.
On : H.323 calls will be allowed.
Off : H.323 calls will not be allowed.
HopCount: <..55>
Specifies the hop count to be used when sending an alias search request to this zone.
Note: if the search request was received from another zone and already has a hop count assigned, the lower of the two values will be used.