TANDBERG D14049.01 - Manual (Page 152)

D 14049.01
07.2007 5
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xCommand
xCommand Description Parameters
LinkAdd Adds and configures a new link. LinkName (r) : <S: , 50>
Assigns a name to this link.
Node: <S: , 50>
Specifies the first zone or subzone to which this link will be applied.
Node: <S: , 50>
Specifies the second zone or subzone to which this link will be applied.
Pipe: <S: , 50>
Specifies the first pipe to be associated with this link.
Pipe: <S: , 50>
Specifies the second pipe to be associated with this link.
LinkDelete Deletes a link. LinkId (r) : <..600>
The index of the link to be deleted.
Locate Runs the VCS’s location algorithm to locate the endpoint
identified by the given alias, searching locally, on neighbors,
and on systems discovered through the DNS system, within
the specified number of “hops”. Results are reported back
through the xFeedback mechanism, which must therefore
be activated before issuing this command (e.g. xFeedback
register event/locate). Alias (r) : <S: , 60>
The alias associated with the endpoint you wish to locate.
HopCount (r) : <0..55>
The hop count to be used in the search.
Protocol (r) : <H33/SIP>
The protocol used to initiate the search.
OptionKeyAdd Adds a new option key to the VCS. Key (r) : <S: 0, 90>
Specifies the key of the software option to be added.
OptionKeyDelete Deletes a software option key from the VCS. OptionKeyId (r) : <..64>
Specifies the ID of the software option to be deleted.