Text goes here, Command reference - xconfiguration – TANDBERG D14049.01 User Manual
Page 143
D 14049.01
07.2007
43
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
TANDBERG
VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Command Reference - xConfiguration
Zones
cont...
LocalZone
cont...
Traversal
cont...
H33
cont...
Preference: <Assent/H4608>
If an endpoint that is registered directly with the VCS supports both Assent and H.460.18 protocols, this setting
determines which the VCS uses.
Assent
: the Assent protocol will be used.
H46018
: the H.460.18 protocol will be used.
TCPProbe
KeepAliveInterval: <..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered
directly with the VCS will send a TCP probe to the VCS once a call is established, in
order to keep the firewall’s NAT bindings open.
RetryCount: <..65534>
Sets the number of times traversal-enabled endpoints registered directly with the
VCS will attempt to send a TCP probe to the VCS.
RetryInterval: <..65534>
Sets the frequency (in seconds ) with which traversal-enabled endpoints registered
directly with the VCS will send a TCP probe to the VCS.
UDPProbe
KeepAliveInterval: <..65534>
Sets the interval (in seconds) with which a traversal-enabled endpoint registered
directly with the VCS will send a UDP probe to the VCS once a call is established,
in order to keep the firewall’s NAT bindings open.
RetryCount: <..65534>
Sets the number of times traversal-enabled endpoints registered directly with the
VCS will attempt to send a UDP probe to the VCS.
RetryInterval: <..65534>
Sets the frequency (in seconds ) with which traversal-enabled endpoints registered
directly with the VCS will send a UDP probe to the VCS.