Mode: <None/Limited/Unlimited>
Determines whether this subzone has a limit on the total bandwidth of calls being
used by its endpoints at any one time.

None

: no bandwidth will be available.

Limited

: there will be a limit on the bandwidth.

Unlimited

: there will be no limit on the bandwidth.

Limit: <..00000000>
(applies only if Mode is set to Limited)
Sets the total bandwidth limit (in kbps) of this subzone.

Name: <S: , 50>
Assigns a name to this subzone.

Subnet [..5]

Address: <S: 0, 39>
Specifies an IP address used (in conjunction with the IP Prefix Length) to identify a subnet to be
assigned to this subzone.

PrefixLength: <0..128>
Specifies the number of bits of the Subnet IP address which must match for an IP address to
belong in this subzone.

Traversal

H33

Assent

Mode: <On/Off>
Determines whether or not H.323 calls using Assent mode for firewall traversal will
be allowed. Applies to traversal-enabled endpoints registered directly with the VCS.

: calls using Assent mode will be allowed.

Off

: calls using Assent mode will not be allowed.

H4608

Mode: <On/Off>
Determines whether or not H.323 calls using H.460.18 mode for firewall traversal
will be allowed. Applies to traversal-enabled endpoints registered directly with the
VCS.

: calls using H.460.18 mode will be allowed.

Off

: calls using H.460.18 mode will not be allowed.

H4609

Demultiplexing

Mode: <On/Off>
Determines whether the VCS will operate in Demultiplexing
mode for calls from traversal-enabled endpoints registered
directly with it.

: allows use of the same two ports for all calls.

Off

: Each call will use a separate pair of ports for media.

Advertising

Popular Brands

Popular manuals