Tunturi T80 User Manual
Page 3
GB
O W N E R ’ S M A N U A L
•
T 8 0 T 8 5
3
there. You’ll find information about using your
exercise equipment and what makes for efficient
training at Tunturi’s website at
WWW.TUNTURI.COM.
ASSEMBLY
Before assembling the device, insure all parts are
present:
pACKAGE 1/2
1.
Running base
pACKAGE 2/2
2.
Lower frame
3.
Handrails
4.
Handlebar/console unit
5.
Power cord
6.
Assembly kit (contents are marked with an * in the
spare part list): keep the assembly tools, as you may
need them e.g. for adjusting the equipment
The directions left, right, front and back are defined
as seen from the exercising position. In case of
problems contact your Tunturi dealer. The package
includes a silicate bag for absorbing moisture during
storage and transportation. Two people are needed
for the installation. Assemble the equipment as
follows:
Begin the assembly with package 2/2.
Do not remove the styrox foam pieces from under
the running base!
HANDRAILS
Fasten each handrail to the lower frame with four
bolts (A). Ensure that the base of the plastic cap at
the lower end of the handrails is lined up with the
hole in the lower frame. Be careful not to damage
the wire coming out of the left handrail.
NOTE!
Do
not tighten these bolts until the handlebar and
console have been secured.
HANDLEBAR AND CONSOLE
Turn the sliders located at the sides of the
handlebars downward so that you can attach them
with another screw (B) through the lower hole of
the handlebar.
NOTE!
Attach the screws as loosely as
possible. Do not remove the screws on the sliders.
Place the handlebar/console unit on the handrails
so that the sliders fit the handrail grooves. Connect
the wire coming out of the left handlebar with the
connector in the console and push the connected
wire inside the handlebar. Push the handlebar/
console unit onto the handrail ends and tighten all
the hex screws on the sliders. Fasten the handrail
bolts. Remove the protective film from the display.
RUNNING BASE
Secure the attached lower frame and handlebar
to the running base according to the following
instructions:
1.
Remove the styrox foam piece from under the
front end of the running base as well as the boards
at the sides of the running base.
2.
Turn forward the transportation wheels located at
the front end of the handlebar/console unit. Lift the
front end of the running base, and then push the
attached lower frame and handlebar under the front
end of the running base so that the front support of
the lower frame and the holes in the running base
are lined up.
NOTE!
Be careful not to damage the
wire.