American Magnetics 4Q1010PS-430 Integrated Power Supply System - Manual (Page 125)

Rev. 5 107
Remote Interface Reference
IEEE-488 Configuration
the parameters under the Net Setup submenu (see sections 3.10.5.2,
3.10.5.3 and 3.10.5.4). To make the values dynamically assigned by a
network DHCP server, set IP Address Assignment to DHCP (see section
3.10.5.1).
The system name (also known as host name or computer name), can be set
using remote communications (either Ethernet or RS-232); it cannot be
edited using the front panel keypad.
All network parameters (even those assigned by a DHCP server) can be
viewed using the Net Settings submenu (see section 3.10.4).
4.4.1 Ethernet Connector
The Model 430 Programmer uses a standard RJ-45 jack for Ethernet
communications. The Ethernet jack pinout is fully documented in Table A-
6 on page 153 in the Appendix.
4.4.2 Termination Characters
All commands and queries are transmitted and received as ASCII values
and are case insensitive. The Model 430 Programmer always transmits
<CR><LF> (a carriage return followed by a linefeed) at the end of an
Ethernet transmission. The Model 430 can accept <CR>, <LF>,
<CR><LF>, or <LF><CR>, or a semicolon ( ; ) as termination characters
from an external computer.