American Magnetics 4Q1010PS-430 Integrated Power Supply System - Manual (Page 91)

Rev. 5 73
Operation
Example Setup
The Current Limit accessible in the Load submenu should be set to the
rated current to prevent accidental operation of the magnet above rated
field/current. The magnet specification sheet also indicates whether a
persistent switch is installed and provides the recommended heating
current. The persistent switch information is entered in the Load
submenu.
EXCELLENCE IN MAGNETICS AND CRYOGENICS
American Magnetics, Inc.
P.O. Box 2509, 112 Flint Road, Oak Ridge, TN 37831-2509
Phone: (865) 482-1056
Fax: (865) 482-5472
Internet: http://www.americanmagnetics.com E-mail: [email protected]
0$*1(763(&,),&$7,216
AMI JOB #  MAGNET # 
TYPE: 6ROHQRLG
MODEL: &XVWRP
FOR: $ : &U\R(QJLQHHULQJ/WG
DATE: 0D\
Rated Central Field @ 4.2K
1
--------------------------------- N*
Rated Current ------------------------------------------ DPSV
Max. Field Tested ------------------------------------------ N*
Field to Current Ratio ----------------------------- JDXVVDPS
Homogeneity over a 1 cm DSV -------------------------------- “
Measured Inductance ----------------------------------- KHQU\V
Charging Voltage --------------------------------------- YROWV
Axial Clear Bore --------------------------------------  LQFKHV
Overall Length (flange to flange) -------------------- LQFKHV
Maximum Outside Diameter ------------------------------ LQFKHV
Weight --------------------------------------------------- OEV
Recommended Persistent Switch Heater Current --------------- P$
Persistent Switch Heater Nominal Resistance 2 ------------ RKPV
Magnet Resistance in Parallel with Switch 2 -------------- RKPV
Mounting: KROHVWDSSHGIRU0;RQWRSIODQJHHTXDOO\VSDFHG
RQDLQFKEROWFLUFOHGLDPHWHU
1. Magnet not warranted for operation above 80 kG.
2. All resistance measurements made at room temperature.
Figure 3-13. Example Magnet Specification Sheet.