GE Industrial Solutions AF-300E$ - Manual (Page 40)

4-9
Control Terminal Board Cont'd
HLD 3-wire Operation - When 3-wire operation is selected and HLD-CM is closed, the pulse
Stop Command signal input from FWD, REV terminals is held internally.
(Operation From
Momentary Contacts)
RST Reset Signal Input After removal of fault condition, Faults are reset when a momentary
contact closure is made between the RST-CM terminals for more than
0.1 seconds.
NOTE:
If there is an input to the FWD and/or REV terminals, the unit
will not RESET.
THR External thermal trip With THR-CM (open), OH2 trip will occur and the motor will
command coast-to-stop.
NOTE:
With no external thermal relay or external braking resistor
thermostat, the THR-CM terminals must be closed or the drive
will not operate. OH2 is a latched fault.
FMA Frequency Meter Provides an output of 0 to +10 VDC (+10Vdc at max. frequency.)
Connection Points Available for connection of a voltmeter (with internal resistance of
Analog 10K ohms.) See Function Code 46 for monitoring selection. Meter
connects between terminal FMA & 11. Two (2) voltmeters, each having
an internal resistance of 10K
Ω
can be connected in parallel.
FMP Frequency Meter Pulse frequency output equal to drive output frequency multiplied
Connection Points by the set value of Function Code 43. Meter connects between FMP
Pulse and CM.
AX1 Run Relay Dry Contact is closed when the drive is running. (Contact rating
AX2 Contact Output resistive load: 250 VAC, 0.3 Amps.) (Only applicable to 40 Hp and greater)
30A Fault Relay Output During normal operation, the relay is not energized and contact is made
30B Terminals between 30B and 30C. When a fault is detected, the relay is energized
30C and contact is made between 30A and 30C. (Contact rating resistive
load: 250 VAC, 0.3 Amps.)
X1-X5 Multi-step Input – Seven preset speed selection
Function Selection – Increment/Decrement function
– DC Brake command
– 2nd motor selection
– Switching operation from ac line to Inverter
– Data protection
Y1-Y5 Multi-step Output – Drive running
Function Selection – Frequency equivalence signal
– Frequency level detection
– Pattern timing signal
– Overload early warning
– Under voltage detection
– Keypad operation
– Auto restart
– Auto reset
Table 5: Terminal Identification/Function (continued)
Terminal Terminal
Label Name Function