GE Industrial Solutions AF-300E$ - Manual (Page 7)

2-2
Drive Keypad Functions and Layout
Attachment Screws -The Keypad Panel can be easily
removed from the Drive unit by loosening the two attach-
ment screws. With the optional extension cable, remote
Keypad operation and display is possible.
LCD Graphic Display - LCD Display shows control sta-
tus or Function Code settings.
PROGRAM (PRG) Key - Operation Mode or Program Mode
selection key.
SHIFT (>>) Key - Changes the digital monitor display in
the Operation Mode. Will also change the LCD graphic
display in Program Mode and Trip Mode.
SET FUND/DATA Key - Displays data setting of selected
Function Codes. Also, stores any changes in software.
RESET Key - After removal of the fault condition, faults
can be reset and will return the Drive to the Operation Mode.
Remote/Local Operation - Remote/Local operation can
be toggled by pressing the RESET and STOP keys simul-
taneously when the Drive is stopped.
RUN Key - This key is the RUN command in Keypad op-
eration, run light will be illuminated at this time.
STOP Key - This key is used for stopping operation. If
pressed when the Drive is running by external control, fault
Er6 will be displayed and Drive will coast to a stop.
UP - DOWN Keys - These keys increase or decrease the
frequency (or speed) of the Drive. When unit is in Program
Setting Mode, they change the Function Code or Data Code
values.
LCD Brightness - Function Code 79 permits adjustment
for easy to read brightness of the graphic display.
Unit Display - The unit information is displayed by LEDs
during RUN or STOP condition.
Digital Monitor - Displays Hz, Volts, R/Min, M/Min, or %
as set by the operator using the SHIFT (>>) key or resetting
Function Code 61.
Indication of keypad panel operation
Function/Data Key
Figure 2-2. KEYPAD PANEL COMPONENT IDENTIFICATION
Stop Key
Reset Key
Shift Key
Program Key
Digital Monitor (4-digit)
LCD Graphic Display
}
Unit displayed
Up - Down Keys
Run Light
Run Key