Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 109)

Logic Functions - Book 1
MODCELL SERIAL COMMUNICATION BLOCK
4-27
14 Framing error (FRAMES)...................................................................................................CWR
This diagnostic checks if a stop bit is received for a byte as detected by the 68032.
ENABLE 0 Diagnostic error is not suppressed and errors are reported to the
System Event block. The error message is reported as “FRAMING
ERROR.” This indicates no stop bit detected by the 68032 for a
received byte.
SUPPRESS 1 Diagnostic error is suppressed. Acknowledgement status remains
clear.
15 Framing Error Unacked (FRAMEU) ................................................................................. – WR
If the framing error diagnostic is enabled, this status indicates if the diagnostic is or is not
unacknowledged. The status can be acknowledged or read as follows.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
16 Noise error (NOISES) ........................................................................................................CWR
This diagnostic checks if the three samples for a bit are identical. Diagnostic is detected by
the 68302.
ENABLE 0 Diagnostic error is not suppressed and errors are reported to the
System Event block. The error message is reported as “NOISE
ERROR.” This indicates the three samples for a bit were not
identical.
SUPPRESS 1 Diagnostic error is suppressed. Acknowledgement status remains
clear.
17 Noise Error Unacked (NOISEU)....................................................................................... – WR
If the noise error diagnostic is enabled, this status indicates if the diagnostic is or is not
unacknowledged. The status can be acknowledged or read as follows.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
18 Overrun error (ORUNS).....................................................................................................CWR
This diagnostic checks if the central processor can store a received byte by the time the next
byte is received. Diagnostic is detected by the 68302.
ENABLE 0 Diagnostic error is not suppressed and errors are reported to the
System Event block. The error message is reported as “OVERRUN
ERROR.” This indicates the central processor could not store a
received byte before the next byte was received.
SUPPRESS 1 Diagnostic error is suppressed. Acknowledgement status remains
clear.
19 Overrun Error Unacked (ORUNU) ................................................................................... – WR
If the overrun error diagnostic is enabled, this status indicates if the diagnostic is or is not
unacknowledged. The status can be acknowledged or read as follows.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.