Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 92)

Logic Functions - Book 1
LOOP BLOCK
4-10
11 Restart Failure Unacked (FAILU) .....................................................................................– WR
If the restart failure diagnostic is enabled, this status indicates if the diagnostic is or is not
unacknowledged. The status can be acknowledged or read as follows.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
12 Invalid message (MSGS) .................................................................................................. CWR
This diagnostic checks if the message code of a received message is valid or is supported by
the software.
SUPPRESS 1 Diagnostic error is suppressed. Acknowledgement status remains
clear.
ENABLE 0 Diagnostic error is not suppressed and errors are reported to the
System Event block. The error message is reported as “INVALID
MESSAGE”. This indicates the message code of a received
message was invalid or is not supported by the software.
13 Invalid Message Unacked (MSGU) ..................................................................................– WR
If the invalid message diagnostic is enabled, this status indicates if the diagnostic is or is not
unacknowledged. The status can be acknowledged or read as follows.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
14 Message data invalid (CRCS) .......................................................................................... CWR
This diagnostic checks if a received message can be processed using a Cyclical Redundancy
Check (CRC) check.
SUPPRESS 1 Diagnostic error is suppressed. Acknowledgement status remains
clear.
ENABLE 0 Diagnostic error is not suppressed and errors are reported to the
System Event block. The error message is reported as “MESSAGE
DATA INVALID”. This indicates a received message could not be
processed because it failed the CRC check.
15 Check-Sum Error Unacked (CRCU).................................................................................– WR
If the message data invalid diagnostic is enabled, this status indicates if the diagnostic is or is
not unacknowledged. The status can be acknowledged or read as follows.
NO 0 Diagnostic error is acknowledged.
YES 1 Diagnostic error is unacknowledged.
16 Framing error (FRAMES) .................................................................................................. CWR
This diagnostic checks if a stop bit is received for a byte as detected by the 68032.
SUPPRESS 1 Diagnostic error is suppressed. Acknowledgement status remains
clear.
ENABLE 0 Diagnostic error is not suppressed and errors are reported to the
System Event block. The error message is reported as “FRAMING
ERROR”. This indicates no stop bit detected by the 68032 for a
received byte.