Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 73)

Logic Functions - Book 1
LOOP BLOCK
3-47
7 Remote state error unack quality (RSTUQ) ....................................................................– – R
The remote state error unacknowledged always has good quality.
GOOD 0 Quality is always good.
8 Remote state error Active (RSTA)................................................................................... – WR
If the remote state invalid or has bad quality diagnostic error check is enabled, this status
indicates if the diagnostic is or is not active. The status is writable only in debug and can be
read as follows.
NO 0 Diagnostic error is not active.
YES 1 Diagnostic error is active.
9 Remote state error Active quality (RSTAQ) ....................................................................– – R
The remote state error active always has good quality.
GOOD 0 Quality is always good.
10 State value to use when remote state error occurs (REST) ..........................................CWR
The remote error state is a composite of state and remote state, indicating loop's actual
behavior. If block state is RUN and remote state has an invalid value, or bad quality when bad
inputs are not accepted, then composite state takes on this value. Valid values are:
RUN 0
HOLD 1
OFF 2
DEBUG 3
11 Scan Group (GROUP)....................................................................................................... C – R
The scan group to which this loop block, and the function blocks between it and the next loop
block, are assigned. Group choices are: 1, 2, 3, 4, or 5.
12 Composite State (CSTATE)...............................................................................................– – R
Composite of local and remote state. Valid states are: RUN, HOLD, OFF, or DEBUG. The
loop's function blocks only get called if composite state is RUN. Otherwise, the loop block
manages the diagnostics for each of the function blocks in the loop.
13 Console Status (CNSTATUS)............................................................................................– – R
Used to indicate console status of controlling source for all blocks in the loop.
Free 0 Indicates no console has control.
Busy 1 Indicates some console has control.
14 Computer Status (CPSTATUS) .........................................................................................– – R
Used to indicate computer status of controlling source for all blocks in the loop.
Free 0 Indicates no computer has control.
Busy 1 Indicates some computer has control.
Inactive 2 Indicates no computer control, since there are no authorized
computer sources.