Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 209)

Logic Functions - Book 1
REMOTE DIGITAL OUTPUT MODULE BLOCK (RDOM)
6-31
111, 113.. 141 Track Status,Channel 0 (TRKSTA0) through Channel 15 (TRKSTA15)........................... – WR
Track status is set to track whenever the path from the input to the result is broken. This
occurs when the data quality is bad, the I/O lock is locked, or when the mode is manual.
NO TRACK 0 Data quality is good, I/O lock is unlocked and mode is auto.
TRACK 1 Data quality is bad, I/O lock is locked or mode is manual.
112 ,114.. 142 Track Status Quality,Channel 0 (TRKQ0) through Channel 15 (TRKQ15)...................... – WR
This data quality field is not changed by any internal logic and is always be GOOD unless
written otherwise.
170 - 185 Input Value, Channel 0 (I0) through Channel 15 (I15) CWR
This is the input to each block channel used to determine the output of the channel. The input
type can be configured as either local or remote.
Input Type - Local
Value is local discrete data. This value can be written when the block is in auto.
FALSE 0
TRUE 1
Input Type - Remote
Value is obtained from a connection to any discrete logical source pointer.
210 Packed Results (PKDR).....................................................................................................CWR
The results of block evaluation expressed as packed bits. Each of the 16 channels is
represented by one bit but only the bits for channels in use are meaningful (see attribute 14).
The results are writeable when I/O is locked or the instrument state is not run, Results can
also be written when at least one channel is in manual; only the channels in manual are
changed in this case. The channel 0 result is the least significant bit and the results are
indicated as follows:
FALSE 0
TRUE 1
211 Packed Results Quality (PKDRQ) ...................................................................................... – WR
The quality bits corresponding to the packed results, attribute 210. Quality is writeable under
the same conditions as described for attribute 210. The channel 0 result quality is the least
significant bit and quality is indicated as follows:
GOOD 0
BAD 1
212, 214...242 Initial Result,Channel 0 (R0) through Channel 15 (R15) ...................................................CWR
The initial result is the value used for each channel when the block is initially downloaded.
This value is overwritten when the block first executes. Subsequent values are the result of
block evaluation after action is applied. This value is writeable only when the block mode is
manual, when I/O is locked, or the instrument state is not run.
FALSE 0 Result sent to output module (after action is applied) is open.
TRUE 1 Result sent to output module (after action is applied) is closed.