Micromod MOD: 1800P - MOD 30ML Identity Module (Version 2) System, I/O and Communications Functions - Manual (Page 72)

Logic Functions - Book 1
LOOP BLOCK
3-46
Remote state error Active
quality RSTAQ GOOD (0) – – R Discrete 09
State value to use when
remote state error occurs REST RUN(0), HOLD(1), OFF(2),
DEBUG(3) CWR Short State 10
Scan Group GROUP 1, 2, 3, 4, 5 C – R Short State 11
Composite State CSTATE RUN(0), HOLD(1), OFF(2),
DEBUG(3) – – R Short State 12
Console Status CNSTATUS FREE (0), BUSY (1) – – R Short State 13
Computer Status CPSTATUS FREE, BUSY, INACTIVE(2) – – R Short State 14
Remote State Input RSTATE NONE, RUN, HOLD, OFF,
DEBUG, or LSP (discrete,
short or long state) CWR Short State 15
2 State (STATE) .................................................................................................................... CWR
When state is RUN, the loop's behavior can be determined by the remote state variable, if
present. When state is not RUN, behavior is determined by state and remote state is ignored.
See Section 2.4.1, State Changes for additional information.
RUN 0 Normal Operation. Block is executed.
HOLD 1 Non-executing RUN. Block is not executed.
OFF 2 Block is not executed. Qualities will be BAD.
DEBUG 3 No fields are updated. All attributes are writable.
3 Bad Inputs (BADINP)......................................................................................................... CWR
See Section 2.3.2, Data Quality for additional information.
Rejected 0 Block checks the remote state input quality and if it has bad quality,
then composite state takes on the remote error state value.
Accepted 1 The remote state input is not checked for quality and output quality is
set to good.
4 Diagnostic Suppression Group (SUPPGRP) .................................................................. CWR
NONE, or one of the seven possible diagnostic groups (1, 2, 3, 4, 5, 6, or 7). Assign the
diagnostic points for this loop block to the group desired. The System Event block can
suppress the reporting of diagnostic errors associated with a particular group.
5 Remote State Invalid or has bad quality (RSTS)............................................................ CWR
Block checks the remote state input and if it has an invalid value, then composite state takes
on the remote error state value.
ENABLE 0 Report this diagnostic error.
SUPPRESS 1 Do not report this diagnostic error.
6 Remote state error unacknowledged (RSTU).................................................................– WR
If the remote state invalid or has bad quality diagnostic error check is enabled, this status
indicates if the diagnostic is or is not acknowledged. The status can be acknowledged or read
as follows.
NO 0 Diagnostic error is unacknowledged.
YES 1 Diagnostic error is acknowledged.