Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 100)

90 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Replacing a power supply
8
DRAFT: BROCADE CONFIDENTIAL
• If you are removing the module without replacing it, place the blank faceplate over the
opening where the 10 Gbps module was installed. Use the two captive screws to fasten
the faceplate in place.
Installing a 2-port 10 Gbps module
Follow these procedures and refer to Figure 55 when installing a 10-Gigabit Ethernet Module:
1. Remove power to the FGS or FGS-STK device. For AC power supplies, turn the switch to the
OFF position. For DC power supplies, turn off the DC power source or disconnect it from the
power supply.
2. If necessary, remove the faceplate for the 2-port 10 Gbps module located in the lower
left-hand corner of the front panel. Use a #2 Phillips-head screwdriver or flathead screwdriver
to loosen the two captive screws that secure it in place. Place the blank faceplate in a safe
place for future use.
3. Remove the new 10-Gigabit Ethernet module and faceplate from its protective packaging.
4. Install the 10-Gigabit module in the device as shown in Figure 55 :
• Properly place and align the 10-Gigabit Ethernet module inside the device.
• Push the module firmly toward the back of the device until the front panel is flush with the
rest of the device. This action causes the module connector to lock into the backplane
connector.
• Use a #2 Phillips-head screwdriver or flathead screwdriver to fasten the two captive screws
on the 10-Gigabit module. Affix the screws loosely at first, then tighten them once you are
sure the module is properly positioned.