Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 35
Brocade FastIron GS and GS-STK Hardware Installation Guide
25
53-1002186-02
Installing a redundant power supply
2
DRAFT: BROCADE CONFIDENTIAL
FIGURE 19
Inserting the power supply
CAUTION
Make sure you insert the power supply right-side up. It is possible to insert the supply upside
down, although the supply will not engage with the power backplane. The power supply is
right-side up when the power connector is on the left and the fan vent is on the right.
5. Press the two latches near the edges of the supply outward to lock the supply in place.
6. Replace the power supply locking screw.
7. Install the power cord, and secure it wIth the retaining bail, as shown in
.
NOTE
The edges of the power supply panels will extend approximately .25 in.beyond the side of the device.