Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 59
Advertising
Brocade FastIron GS and GS-STK Hardware Installation Guide
49
53-1002186-02
Upgrading hardware
4
DRAFT: BROCADE CONFIDENTIAL
8. To replace the memory DIMM, refer to
on page 50. Open the DIMM holder by
pushing the tabs apart. Lift the old DIMM up and pull it out of the holder.
CAUTION
Memory DIMMs are not interchangeable between FGS and FLS devices. Make sure you are
installing the correct DIMM for your device (refer to
FIGURE 41
FGS memory DIMM
9. Slide the new DIMM into the holder at an angle (refer to the illustration) and push the
connector end into the holder until it snaps into place.
10. Push straight down on the DIMM to lock it into place in the holder.
Advertising