Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 52)

42 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Upgrading hardware
3
DRAFT: BROCADE CONFIDENTIAL
FIGURE 37 EEPROM Socket Locations on FGS 624 and 648 Devices
3. Replace the cover:
• Hold the cover on each side at the center and align the front of the cover with the end of
the serial interface on the front panel, so that the cover extends slightly past the front
panel of the device.
• Slide the cover backwards until it is fully flush with the top of the device and slides into
place.
• Re-insert the cover screws.
4. If applicable, re-attach the rack mounting ears.
5. Reinstall the device in the equipment rack, if applicable.
6. Re-insert any power cables and power on the device.
Your EPREM upgrade is now complete. Refer to the FastIron Configuration Guide for information
about the Edge Layer 3 features available with release 04.3.01.
1 Device front panel
2 Power supplies
3 Device rear panel
4 Pin 1 and socket hole 1
5 EEPROM socket
6 EEPROM
7 Memory DIMM
1
2
3
7
2
4
5 6