Cleaning the fiber optic connectors – Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 107
Brocade FastIron GS and GS-STK Hardware Installation Guide
97
53-1002186-02
Cleaning the fiber optic connectors
8
DRAFT: BROCADE CONFIDENTIAL
4. Observe the link and active LEDs to determine if the network connections are functioning
properly. For more information about the LED indicators, refer to
Cleaning the fiber optic connectors
To avoid problems with the connection between the fiber optic module (SFP (mini-GBIC) or XFP) and
the fiber cable connectors, Brocade strongly recommends cleaning both connectors each time you
disconnect and reconnect them. In particular, dust can accumulate in the connectors and cause
problems such as reducing the optic launch power.
To clean the fiber cable connectors, Brocade recommends using the fiber-optic reel-type cleaner
that shipped with your Brocade device. You can also purchase this type of cleaner from the
following Website:
http://www.fisfiber.com
When not using an SFP or XFP connector, make sure to keep the protective covering on.