Figure 42, Draft: brocade confidential – Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 60
Advertising
50
Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Upgrading hardware
4
DRAFT: BROCADE CONFIDENTIAL
FIGURE 42
Replacing the memory DIMM
11. If you are also installing a CX4 10GB module, proceed to
. If you are not
installing a CX4 module, proceed to
.
12. Remove the cover plate from the module slot on the front panel, as shown in
1. Push memory socket tabs away from DIMM
2. Pull old DIMM up and out of holder at an angle
(see side view)
3. Slide new DIMM gently into holder at an angle
until you feel the connector end snap into place
4. Press DIMM into holder until it is flat and the tabs
on each side click into place
Side view
Advertising