Figure 38, Draft: brocade confidential – Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 57
Advertising
Brocade FastIron GS and GS-STK Hardware Installation Guide
47
53-1002186-02
Upgrading hardware
4
DRAFT: BROCADE CONFIDENTIAL
FIGURE 38
Removing Cover Screws on FGS Devices.
5. Remove the cover by sliding it back slightly and then lifting it off as shown in
.
FIGURE 39
Removing the cover from FGS Devices
6. Remove the EEPROM from the package and align the lead pins over the EEPROM socket. Refer
on page 48 for the EEPROM socket and Memory DIMM locations on FGS devices.
•
The semicircular indentation on the EEPROM is located on the same end as pin 1.
.
7. Align the semicircular indentation on the EEPROM with the semicircular cut-out on the
EEPROM socket and gently push the EEPROM into the socket.
Slot 3
Slot 3
1
2
Advertising