Upgrading software – Brocade FastIron GS and GS-STK Hardware Installation Guide User Manual
Page 62
Advertising
52
Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Upgrading Software
4
DRAFT: BROCADE CONFIDENTIAL
17. Reconnect power cables to the device.
Your memory and stacking EEPROM hardware upgrade is now complete. Proceed to the next
section which has procedures for upgrading your software.
Refer to
“Installing FastIron GS-STK stackable devices”
on page 33 for information on how to cable
your devices for stacking, and the FastIron Configuration Guide for information about how to
operate your device in an IronStack.
Upgrading Software
After you install your EEPROM and memory upgrade components, you will need to upgrade your
software to version 05.0.01 or later. Refer to the procedures in the release notes.
Advertising