Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 58)

48 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Upgrading hardware
4
DRAFT: BROCADE CONFIDENTIAL
CAUTION
Make sure you insert the EEPROM so that pin 1 goes into the correct hole as shown in the
illustrations. If you accidentally insert the EEPROM backwards, the device will not work and may
be damaged when you power it on.
CAUTION
Do not push too hard. If the EEPROM does not readily go into the socket, stop pushing and verify
that the lead pins are straight and aligned over the holes. Straighten any crooked pins, then try
again.
FIGURE 40 EEPROM and Memory DIMM Locations on FGS Devices
1
2
3
7
2
4
5 6