Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 49)

Brocade FastIron GS and GS-STK Hardware Installation Guide 39
53-1002186-02
DRAFT: BROCADE CONFIDENTIAL
Chapter
3
EPREM Upgrade for FastIron GS Devices
These installation instructions describe how to upgrade your standalone FastIron GS device to
support Edge Layer 3 features (software release FGS 04.3.01 and later).
If you have any questions about performing this upgrade, please contact your place of purchase or
Brocade at 1.877.TURBOCALL (887.2622) inside the United States or 408.207.1600 outside the
United States. You also can send email to [email protected].
Upgrade kit contents
Before beginning the upgrade, verify the contents of your upgrade kit. If any items are missing,
contact your place of purchase. Upgrade kits for FGS 24-port and 48-port devices contain the
following items:
• Electrostatic Discharge (ESD) protection kit
• Edge Layer 3 EEPROM
• Installation Instructions
Upgrading hardware
You need a Phillips-head screwdriver and a static-free work area to perform this upgrade.
WARNING A warning calls your attention to a possible hazard that can cause injury or death.
ACHTUNG "Achtung" weist auf eine mögliche Gefährdung hin, die zu Verletzungen oder Tod führen
können.
AVERTISSEMENT Un avertissement attire votre attention sur un risque possible de blessure ou de décès.
ADVERTENCIA Una advertencia le llama la atención sobre cualquier posible peligro que pueda ocasionar
daños personales o la muerte.
WARNING The procedures in this manual are for qualified service personnel.
ACHTUNG Die Verfahren in diesem Handbuch sind nur für qualifiziertes Wartungspersonal gedacht.
AVERTISSEMENT Les procédures décrites dans ce manuel doivent être effectuées par le personnel de
service qualifié uniquement.
ADVERTENCIA Los procedimientos de este manual se han hecho para personal de servicio cualificado.