Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 68)

58 Brocade FastIron GS and GS-STK Hardware Installation Guide
53-1002186-02
Configuring IP addresses
5
DRAFT: BROCADE CONFIDENTIAL
Syntax: interface ve <num>
Deleting an IP address
To delete an IP address, enter a command such as the following:
FastIron(config-if-e1000-1)# no ip address 1.1.2.1
This command deletes IP address 1.1.2.1. You do not need to enter the subnet mask.
To delete all IP addresses from an interface, enter the following command:
FastIron(config-if-e1000-1)# no ip address *
Syntax: no ip address <ip-addr> | *
Devices running layer 2 software
To configure an IP Address on a device running Layer 2 software:
1. At the opening CLI prompt, enter enable.
FastIron> enable
2. Enter the following command at the Privileged EXEC level prompt (for example, FastIron
Switch#), then press Enter. This command erases the factory test configuration if still present:
FastIron# erase startup-config
CAUTION
Use the erase startup-config command only for new systems. If you enter this command on a
system you have already configured, the command erases the configuration. If you accidentally
do erase the configuration on a configured system, enter the write memory command to save the
running configuration to the startup-config file.
3. Access the configuration level of the CLI by entering the following command:
FastIron
# configure terminal
Privileged EXEC Level
FastIron
(config)#
Global CONFIG Level
4. Configure the IP address and mask for the switch.
FastIron(config)# ip address 192.22.3.44 255.255.255.0
5. Set a default gateway address for the switch.
FastIron(config)# ip default-gateway 192.22.3.1
NOTE
You do not need to assign a default gateway address for single subnet networks.
Syntax: enable [<password>]
Syntax: configure terminal
Syntax: [no] ip address <ip-addr> <ip-mask>
or