Brocade FastIron GS and GS-STK Hardware Installation Guide - Manual (Page 45)

Brocade FastIron GS and GS-STK Hardware Installation Guide 35
53-1002186-02
Powering on the system
2
DRAFT: BROCADE CONFIDENTIAL
NOTE
If you plan to upgrade your existing FGS devices to support stacking, you will need to install an
upgrade kit. Refer to
“Stacking Upgrade for the FastIron GS” on page 45.
Powering on the system
Note the following before powering on the system:
• The power socket should be installed near the equipment and should be easily accessible.
• If the outlet is not rated 115/120V, stop and get the appropriate cable for the outlet.
• If your installation requires a different power cord than that supplied with the device, make
sure you obtain a power cord displaying the mark of the safety agency that defines the
regulations for power cords in your country. The mark is your assurance that the power cord
can be used safely with the device.
After you complete the physical installation of the system, you can power on the system.
1. Ensure that all power supplies are fully and properly inserted and all empty power supply slots
are covered.
CAUTION
Never leave tools inside the device.
2. For DC supplies, connect the power source to the wires to activate the circuit.
3. For AC supplies:
• Remove the power cord from the shipping package.
• Attach the AC power cable to the AC connector on the rear panel and secure with retaining
bale, as shown in
Figure 32 .
FIGURE 32 Attaching the AC power cable
2
1 Power cable retaining bale
2 AC power cable
1
2