West Control Solutions Pro-16 - Manual (Page 63)

Programmer
9499-040-93811 / 59537-1 Page 63 of 88 Pro-16
End
segment The last segment in a program is the end
segment. When reaching the end segment,
output of the setpoint output last is continued.

Waiting and operator call
All segment types except end segment can be combined with ”Wait at the end and
operator call”.
If a segment with combination ”wait” was configured, the programmer goes to stop mode
at the segment end (run LED is off). Now, the programmer can be restarted by pressing the
start/stop key (>3s), via interface or digital input.
1 Segment type = time
2 Segment type = hold
3 Segment type = time and wait
4 Segment type = time
8.1.3 Bandwidth monitoring
Bandwidth monitoring is valid for
all program segments. An
individual bandwidth can be
determined for each program.
When leaving the bandwidth
(
b.Lo = low limit; b.Hi = high
limit), the programmer is stopped
(run LED flashes). The program
continues running when the
process value is within the
predefined bandwidth again.
g
With segment type Step and bandwidth monitoring activated, the control
deviation alarm is suppressed, until the process value is in the band again.
If band alarm signalling as a relay output is required, a control deviation alarm
with the same limits as the band limits must be configured.