West Control Solutions Pro-16 - Manual (Page 64)

Programmer
9499-040-93811 / 59537-1 Page 64 of 88 Pro-16
8.1.4 Search run at programmer start
The programmer starts the first segment at the actual process value (search run). This may
change the effective runtime of the first segment.
8.1.5 Behaviour after mains recovery or sensor error
Mains recovery
After power recovery, the last program set-points and the time elapsed so far are not
available any more. Therefore, the programmer is reset in this case. The controller uses the
internal set-points and waits for further control commands (the run LED blinks).
Sensor error
With a sensor error, the programmer goes to stop condition (the run LED blinks). After
removal of the sensor error, the programmer continues running.