West Control Solutions Pro-16 - Manual (Page 84)

Safety notes
9499-040-093811 / 59537-1 84 Page 84 of 88 9499-040-0 Pro-16
13. Safety notes
This unit was built and tested in compliance with VDE 0411-1 / EN 61010-1 and was
delivered in safe condition.
The unit complies with European guideline 89/336/EWG (EMC) and is provided with CE
marking.
The unit was tested before delivery and has passed the tests required by the test schedule.
To maintain this condition and to ensure safe operation, the user must follow the hints and
warnings given in this operating manual.
The unit is intended exclusively for use as a measurement and control instrument in
technical installations.
Warning!
If the unit is damaged to an extent that safe operation seems impossible,
the unit must not be taken into operation.
ELECTRICAL CONNECTIONS
The electrical wiring must conform to local standards (e.g. VDE 0100). The input
measurement and control leads must be kept separate from signal and power supply leads.
COMMISSIONING
Before instrument switch-on, check that the following information is taken into account:

Ensure that the supply voltage corresponds to the specifications on the type label.

All covers required for contact protection must be fitted.

If the controller is connected with other units in the same signal loop, check that the
equipment in the output circuit is not affected before switch-on. If necessary,
suitable protective measures must be taken.

The unit may be operated only in installed condition.

Before and during operation, the temperature restrictions specified for controller
operation must be met.
SHUT-DOWN
For taking the unit out of operation, disconnect it from all voltage sources and protect it
against accidental operation.
If the controller is connected with other equipment in the same signal loop, check that
other equipment in the output circuit is not affected before switch-off. If necessary,
suitable protective measures must be taken.