Inserting a hard disk drive, 8 firmly plug in the power cable and signal cable, 9 replace the side panel and front door panel – Toshiba Magnia 550d User Manual
Page 100: Removing a hard disk drive –5.25-inch device bay, 2 unplug the power cable, 3 remove the front door panel and side panel
Connecting Hardware Devices
Hard disk drive (HDD) – SCSI HDD –
83
7 Insert the hard disk drive straight into a device bay slot sliding
it on the rails of the slot, and fasten it with the two screws.
Inserting a hard disk drive
8 Firmly plug in the power cable and signal cable.
9 Replace the side panel and front door panel.
10 Plug in the power cable and switch on the server.
Removing a hard disk drive –5.25-inch device bay–
When removing a hard disk drive from the server, first read
“Before you start” of this chapter and follow the instructions given
below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Removing a hard disk drive while the server is turned
on may cause damage to the server or the hard disk drive.
3 Remove the front door panel and side panel.