Toshiba Magnia 550d - Manual (Page 203)

189
3 Switch on the server.
After the CMOS is cleared, all setup information is lost and the
following window appears.
Press the <F1> key, then follow the steps below to reset the CMOS
to its default settings.
1 Select “LOAD OPTIMIZED DEFAULTS” from the Setup
menu to activate it.
2 Set the system date and time under “STANDARD CMOS
SETUP” in the Setup menu.
3 Set the following, using “BIOS FEATURES SETUP” in the
Setup menu.
S.M.A.R.T. for Hard Disks: Enabled
4 Set the following, using “CHIPSET FEATURES SETUP” in
the Setup menu.
SDRAM Timing by SPD: Enabled
DRAM Integrity Mode: Ecc
USB Controller: USB Port 0&1
5 If Windows 2000 Server is installed, set the following, using
“PNP/PCI CONFIGURATION.”
Plug and Play Aware O/S: Yes
CMOS Setting Wrong
CMOS/GPNV Checksum Bad
Press F1 to RUN SETUP
Press F2 to load defaults values and continue