Toshiba Magnia 550d - Manual (Page 110)

Connecting Hardware Devices
SCSI devices
93
11 Install the drive carrier in the server and fasten it with the two
screws.
Engage the rail on the top of the drive carrier with the rail of
the server, and gently push the driver carrier in the direction of
the server’s rear side until you feel a click.
Installing the drive carrier
12 Firmly plug in the power cable and signal cable.
If the power cable cannot be plugged due to the position of the
SCSI device power connector use a free power cable for
connection.
13 From the front door panel, remove the spacer from the device
bay slot to enable the new SCSI device to be installed.
Carefully store the spacer for future use.
Removing the spacer