Toshiba Magnia 550d - Manual (Page 164)

Installing Software
NetWare
148
(2) The CD-ROM drive is recognized on the MS-DOS.
To make the MS-DOS recognize the CD-ROM drive, set up
the MS-DOS environment as mentioned in the preceding step
(1) and set the floppy disk labeled “DOS Disk” (created by the
Server Setup Tool) in the floppy disk drive. Then, operate as
follows:
1 Create the directory XXX in the drive C for installing the
CD-ROM driver. The “XXX” is an arbitrary directory
name.
2 Input “A:” and press the <Enter> key to shift it to the drive
A.
3 Copy the “CDROMDRV.SYS” from the DOS Disk in the
drive A to the XXX directory.
4 Add the following line to the first line of the “Config.sys.”
DEVICE=C:\XXX\CDROMDRV.SYS /D:LITE-CD /
P:170, 0F, M /V
5 Add the following line to the first line of the
“Autoexec.bat.”
C:\DOS\MSCDEX.EXE /D:LITE-CD /M:15
6 Restart the system.
Installing the NetWare 5.1 manually
Selecting the driver when installing NetWare 5.1
When the installation of NetWare 5.1 starts, the installer detects
the SCSI controller and the network adapter, and automatically
assigns drivers contained in the NetWare CD-ROM. However,
use the driver that comes with this system instead of these drivers.