Toshiba Magnia 550d - Manual (Page 98)

Connecting Hardware Devices
Hard disk drive (HDD) – SCSI HDD –
81
Installing a hard disk drive (expansion) –5.25-inch device bay–
When installing a hard disk drive in the server, first read “Before
you start” of this chapter and follow the instructions given below.
1 If the server is in operation, shut it down and switch off the
power.
2 Unplug the power cable.
NOTE: Installation of a hard disk drive while the server is
turned on may cause damage to the server or to the hard disk
drive.
3 Remove the front door panel and side panel.
See “Removing and replacing the server panels” on page 21.
4 Attach the adapter plate for the 5.25-inch device bay to the
hard disk drive to be installed.
Fasten the adapter plate with the four screws on the rear side.
Use the screw A supplied with the server.
See “Before you start” on page 43.
Attaching the adapter plate