Toshiba Magnia 550d - Manual (Page 167)

Installing Software
NetWare
151
Selecting the RAID Controller driver
(when the RAID controller MR475 is installed)
After selecting the SCSI Controller driver by the “Selecting the
SCSI Controller driver” mentioned previously, proceed as follows:
When the SCSI is not used, steps 5, 6 and 7 are not required.
1 Delete “ADPT160M” on the same screen as shown in the
previous section.
2 Set the floppy disk labeled “MegaRAID Drivers for Series
493/475 NetWare/MS-DOS” (supplied with RAID Controller)
in the floppy disk drive.
3 Press the <Insert> key to select “Add an unlisted driver <Ins>.”
4 Press the <F3> key to designate the directory of the floppy disk
as follows.
A: \NetWare
As the driver is detected, it is added to the “List of drivers
currently selected,” as shown below.
5 Insert the Adaptec 29160N NetWare driver for NetWare
created with Server Setup Tool in the floppy disk drive.
6 Press the <Insert> key twice to select the “Add an unlisted
driver <Ins>.”
7 Press the <Enter> key to retrieve drivers contained in the
floppy disk.
The drivers contained in the floppy disk are added to the “List
of drivers currently selected,” as shown below.
Proceed with installation operation following the instructions
that appear on the screen.
|| MEGA4_XX.HAM ||AMI MegaRAID Enterprise 1600/1700/Express 500 Adap ||
|| ADPT160M.HAM || ||