Toshiba Magnia 550d - Manual (Page 154)

Installing Software
Windows NT
® Server 4.0
138
below described procedure to install the display driver after
installing the VIA 4in1 driver:
1 Start up Windows NT Server 4.0, and log in using the
Administrator ID (or user ID having equivalent rights).
2 Select [Start]-[Settings]-[Control Panel]-[Screen], and open
screen properties.
3 Select [Modify] in the sub-screen that pops up by [Display
type] on the [Display Settings] tab.
4 Insert the Server Setup Tool CD-ROM in the CD-ROM drive,
and instruct the following directory at [Use disk].
<CD-ROM>\PUBLIC\VIDEO\GIGABYTE\GA620\NT
5 Select [OK].
6 When the message [Select manufacturer and model of display
adapter] is displayed, select [GA-620 [Vanta] Windows NT
Display Driver] and [OK].
7 When the message [Attempting to install third-party driver ...]
is displayed, select [Yes].
8 When the message [Driver was installed successfully] is
displayed, select [OK]-[Close]-[Close].
9 When the message [Reboot computer to enable new settings]
is displayed, select [Yes].
10 A message is displayed when you log on to Windows NT.
When the "Screen Properties" window opens, set the desired
display mode.
Setting up the network
To ensure correct use of the network, follow the procedure below
to set up the network.
1 Start Windows NT Server 4.0 and log on as an administrator
(or a user with equivalent rights).
2 If no network has been built up, set up the network.
3 Set up the TCP/IP for the network if necessary.